Ultimate Guide: Removing Built-In & Over Range Microwaves, Setting Clock, Mounting Under Cabinet | Expert Tips

How to Remove a Built-In Microwave: A Step-by-Step Guide

Removing a built-in microwave can be a daunting task, especially if you’re not familiar with the process. However, with the right tools and knowledge, it can be a relatively straightforward process. In this article, we will guide you through the steps of removing a built-in microwave, including troubleshooting examples and solution suggestions that users frequently experience. We will also provide information on replacement parts and the importance of calling authorized service centers. So, let’s get started!

1. How to Remove a Built-In Microwave

Before you begin the removal process, make sure to disconnect the microwave from the power source. This is crucial for your safety. Once that’s done, follow these steps:

  1. Locate the mounting screws: Most built-in microwaves are secured to the cabinet or wall with mounting screws. These screws are typically located above the microwave, inside the cabinet.
  2. Remove the mounting screws: Use a screwdriver or drill to remove the mounting screws. Make sure to hold the microwave securely while removing the screws to prevent it from falling.
  3. Disconnect the power cord: After removing the mounting screws, carefully pull the microwave forward to access the power cord. Unplug the power cord from the outlet.
  4. Remove the microwave: With the power cord disconnected, gently lift the microwave off the mounting bracket. It may be helpful to have someone assist you in this step, as built-in microwaves can be heavy.

By following these steps, you should be able to successfully remove your built-in microwave. However, if you encounter any difficulties or face unique challenges, it’s always a good idea to consult the user manual or contact the manufacturer for specific instructions.

2. How to Remove an Over-Range Microwave

Removing an over-range microwave follows a similar process to removing a built-in microwave. However, there are a few additional steps to consider:

  1. Disconnect the vent duct: Over-range microwaves are typically vented to the outside. Before removing the microwave, you’ll need to disconnect the vent duct. This can usually be done by loosening the clamps or screws that hold the duct in place.
  2. Remove the mounting plate: Over-range microwaves often have a mounting plate that attaches to the wall. Remove the screws securing the mounting plate and carefully detach it from the wall.
  3. Follow the steps for removing a built-in microwave: Once the vent duct and mounting plate are removed, you can proceed with the steps outlined in section 1 to remove the microwave itself.

Remember to exercise caution and prioritize safety throughout the removal process. If you’re unsure about any step or encounter any difficulties, it’s best to seek professional assistance.

3. How to Set the Clock on a Microwave

Setting the clock on a microwave is a common task that many users struggle with. Here’s a simple guide to help you set the clock:

  1. Locate the clock button: Look for a button labeled “Clock” or a similar icon on the microwave’s control panel.
  2. Press the clock button: Press the clock button once to enter the clock setting mode.
  3. Set the time: Use the number pad or arrow buttons to adjust the time. Some microwaves may require you to press an “Enter” or “Start” button to confirm the time.
  4. Save the settings: Once you’ve set the correct time, press the clock button again or wait for a few seconds to save the settings.

If you’re still having trouble setting the clock, refer to the user manual or contact the manufacturer for specific instructions. They may have additional tips or troubleshooting steps to help you.

4. How High Should a Microwave Be Above the Stove?

The height at which a microwave should be installed above the stove depends on various factors, including the manufacturer’s recommendations and local building codes. However, a common guideline is to install the microwave between 13 and 16 inches above the stove’s cooking surface.

It’s important to follow the manufacturer’s instructions and consult local building codes to ensure proper installation. Installing the microwave at the correct height not only ensures optimal functionality but also promotes safety in the kitchen.

5. How to Mount a Microwave Under a Cabinet

If you’re looking to mount a microwave under a cabinet, here’s a step-by-step guide:

  1. Choose a suitable location: Select a location under the cabinet that provides enough clearance and is easily accessible.
  2. Mark the mounting holes: Hold the microwave in place and mark the locations of the mounting holes on the bottom of the cabinet.
  3. Drill pilot holes: Use a drill to create pilot holes at the marked locations. Make sure the pilot holes are slightly smaller than the mounting screws.
  4. Attach the mounting bracket: Secure the mounting bracket to the bottom of the cabinet using the provided screws.
  5. Mount the microwave: With the mounting bracket in place, carefully lift the microwave and align it with the bracket. Slide the microwave onto the bracket until it locks into position.

Always refer to the manufacturer’s instructions for specific mounting requirements and weight limitations. If you’re unsure about any step or encounter any difficulties, it’s best to seek professional assistance.

6. Replacement Parts for Built-In Microwaves

If you’re in need of replacement parts for your built-in microwave, it’s important to source them from reliable suppliers. Many manufacturers offer spare parts for their products, which can be purchased directly from their official websites or authorized retailers.

When searching for replacement parts, make sure to have the model number and serial number of your microwave on hand. This information is usually located on a label inside the microwave or on the back of the appliance. Providing these details will help ensure that you receive the correct parts for your specific model.

If you’re unsure about the replacement process or prefer professional assistance, it’s recommended to call the authorized service center. In the United Kingdom, there are service centers located in various provinces. To find the nearest service center, visit the company’s official website and contact the call center specified.


Removing a built-in microwave may seem like a challenging task, but with the right knowledge and tools, it can be done

9 thoughts on “Ultimate Guide: Removing Built-In & Over Range Microwaves, Setting Clock, Mounting Under Cabinet | Expert Tips”

  1. Who needs a microwave when you can just cook everything on the stove? #MicrowaveFreeLife

  2. Wow, I never knew removing a microwave could be such a complicated process!

    1. davidcontactor@gmail.com

      Actually, removing a microwave can be quite simple if you follow the instructions. Maybe you should do some research before making ignorant comments. Just saying.

  3. Step 3: How to summon a magical unicorn to help remove the microwave. Works every time!

    1. davidcontactor@gmail.com

      Are you serious? Summoning a magical unicorn to remove a microwave? Thats the most absurd thing Ive ever heard. Stick to practical advice, please.

  4. I never knew removing a microwave could be so complicated! Who needs a clock anyway?

    1. davidcontactor@gmail.com

      Seriously? Who needs a clock? Maybe people who like to know the time without reaching for their phone every five minutes. But hey, I guess some of us are just too busy to appreciate the little conveniences in life.

  5. Lionel Solomon

    Wow, who knew removing a microwave could be so complicated? Ill stick to takeout, thanks!

    1. davidcontactor@gmail.com

      Removing a microwave may seem complicated, but its not rocket science. Embrace the challenge, learn something new, and save money on takeout. Dont be afraid to step out of your comfort zone, my friend.

Leave a Reply

Scroll to Top